NTE975 Operational Amplifier PDIP-8
Info als pdf File
Integrated Circuit
Operational Amplifier
8-PIN DIP
To order >>> NTE975SM
Description:
The NTE975 and NTE975SM are general purpose operational amplifiers built on a single chip. The resulting close match and tight thermal coupling gives low offsets and temperature drift as well as fast recovery from thermal transients.
The unity-gain compensation specified makes the circuit stable for all feedback configurations, even with capacitive loads. However, it is possible to optimize compensation for the best high frequency performance at any gain. As a comparator, the output can be clamped at any desired level to make it compatible with logic circuits.
Features:
- Available in 8-Lead Mini DIP (NTE975) and Surface Mount, SIOC-8 (NTE975SM)
- Frequency Compensation with a Single 30pF Capacitor
- Operation From ±5V to ±20V
- Low Current Drain: 1.8mA @ ±20V
- Continuous Short-Circuit Protection
- Operation as a Comparator with Differential Inputs as High as ±30V
- No Latch-Up when Common Mode Range is Exceeded
Absolute Maximum Ratings:
| Supply Voltage, VS |
|
±22V |
| Power Dissipation (Note 1), PD |
|
500mW |
| Input Differential Voltage Range, VID |
|
±30V |
| Input Voltage (Note 2), VIN |
|
±15V |
| Output Short Circuit Duration (Note 3), tS |
|
Indefinite |
| Operating Temperature Range, TA |
|
0°C to +70°C |
| Storage Temperature Range, Tstg |
|
-65°C to +150°C |
| Lead Temperature (During Soldering, 10sec), TL |
|
+300°C |
| Note 1. | For operating at elevated temperatures the devices must be derated based on a maximum junction to case thermal resistance of +45°C/W, or +150°C/W junction to ambient. |
| Note 2. | For supply voltages less than ±15V, the absolute maximum input voltage is equal to the supply voltage. |
| Note 3. | Continuous short circuit is allowed for ambient temperatures to +70°C. |
Electrical Characteristics: (0° </= TA </= +70°C, ±5V </= VS </= ±15V unless otherwise specified)
| Parameter |
Symbol |
Test Conditions |
Min |
Typ |
Max |
Units |
| Input Offset Voltage |
VIO |
TA = +25°C, RS </= 10k Ohm |
- |
1.0 |
5.0 |
mV |
| RS </= 10k Ohm |
- |
- |
9.0 |
mV |
| Input Offset Current |
IIO |
TA = +25°C |
- |
40 |
200 |
nA |
| |
- |
- |
300 |
nA |
| Input Bias Current |
IIB |
TA = +25°C |
- |
120 |
500 |
nA |
| |
- |
- |
0.8 |
µA |
| Input Resistance |
rI |
TA = +25°C |
300 |
800 |
- |
kOhm |
| Supply Current |
ID |
TA = +25°C, VS = ±15V |
- |
1.8 |
2.8 |
mA |
| TA = +125°C, VS = ±15V |
- |
1.20 |
2.25 |
mA |
| Large Signal Voltage Gain |
Av |
TA = +25°C, VS = ±15V, VOUT = ±10V, RL = ±2k Ohm |
50 |
160 |
- |
V/mV |
| VS = ±15V, VOUT = ±10V, RL = ±2k Ohm |
25 |
- |
- |
V/mV |
Average Temperature Coefficient
of Input Offset Voltage |
TCVIO |
RS </= 50 Ohm |
- |
3.0 |
- |
µV/°C |
| RS </= 10k Ohm |
- |
6.0 |
- |
µV/°C |
| Output Voltage Swing |
VO |
VS = ±15V, RL = 10 Ohm |
±12 |
±14 |
- |
V |
| VS = ±15V, RL = 2k Ohm |
±10 |
±13 |
- |
V |
| Input Voltage Range |
VICR |
VS = ±15V |
±12 |
- |
- |
V |
| Common-Mode Rejection Ratio |
CMRR |
RS </= 10k Ohm |
70 |
90 |
- |
dB |
| Power Supply Rejection Ratio |
PSRR |
RS </= 10k Ohm |
77 |
90 |
- |
dB |
| Note 4. | The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage range is VCC-1.7V, but either or both inputs can go to +32V without damage. |
| Note 5. | Short circuit from the output to VCC can cause excessive heating and eventual destruction. Destructive dissipation can result from simultaneous shorts on all amplifiers. |
Fehler und Änderungen bei technischen Daten, Abmessungen und Preisen bleiben vorbehalten. Bild kann vom Original abweichen.
Hat sich ein Fehler eingeschlichen?
Bitte hier melden
Suchen Sie nach einem Ersatztypen?
Wir führen die NTE Austausch-Halbleiter in unserem Sortiment
Anmerkung zu den NTE/ECG Austauschhalbleiter:
NTE-Austauschhalbleiter (früher ECG Philips und Sylvania) sind sorgfältig
ausgesuchte und erprobte Halbleiter, die einen sicheren Ersatz
für Originaltypen verschiedenster Hersteller und Ursprünge für
fast alle Applikationsbereiche im Wartungsdienst bieten.
Alle NTE-Austausch-Halbleiter sind einzeln in durchsichtigen
Plastikbeuteln verpackt, auf welchen die wichtigsten Daten
vermerkt sind.
Sprachen integrierter Schaltkreis integrated circuit, kurz IC, Mikrochip Microchip integreret kredsløb integreret kredslob circuito integrado (CI) circuit intégré (CI) circuit integre (CI) circuito integrato geïntegreerde schakeling geintegreerde schakeling Tümdevre Tuemdevre
