20.20CHF
ab 10 18.46CHF
ab 50 17.43CHF
ab 100 16.42CHF

NTE949 Dual Audio OP Amplifier/Preamplifier 8-Pin Metal Can

Bestell-Nr.:    NTE949


Verfügbarkeit:     PICTURE_ONLY_ZERO
  auf Anfrage !


NTE949 Dual Audio OP Amplifier/Preamplifier 8-Pin Metal Can

Info als pdf File

Integrated Circuit Dual Audio Operational Amplifier/Preamplifier
8-PIN METAL CAN

Description:

The NTE949 consists of two identical high gain OP amps constructed on a single 8-Lead Metal Can type package. These three-stage amplifiers use Class A PNP transistor output stages with uncommitted collectors. This enables a variety od loads to be employed for general purpose applications from DC to 10MHz, where two high performance operationa amplifiers are required. In addition, the outputs may be wored-OR for use as a dual comparator or they may function as diodes in low threshold rectifying circuits such as absolute value amplifiers and peak detectors.

Features:

  • Single or Dual Supply Operation
  • Low Power Consumption
  • High Gain:  25,000 V/V
  • Large Common Mode Range:  +11V, -13V
  • Excellent Gain Stability vs. Supply Voltage
  • No Latch-Up
  • Output Short Circuit Protected
Absolute Maximum Ratings:
Supply Voltage, V+, V-     ±18V
Internal Power Dissipation (TA = +70°C), PD     500mW
            Derate Above 70°C     6.8mW/°C
Input Differential Voltage, VID     ±5V
Input Common-Mode Range (Note 1), VICR     ±15V
Operating Temperature Range, Topr     0° to +70°C
Storage Temperature Range, Tstg     -65° to +150°C
Lead Temperature (During Soldering, 60sec max), TL     +300°C
Output Short-Circuit Duration (TA = +25°C, Note 2), tOS     30sec

Note 1.For supply voltages less than ±15V, the absolute maximum input voltage is equal to the supply voltage.
Note 2.Short circuit may be to GND oer either supply.

Electrical Characteristics: (TA = +25°C, V+ = ±15V, RL = 5k Ohm to Pin7 unless otherwise specified)

Parameter Symbol Test Conditions Min Typ Max Units
Input Offset Voltage VIO RS = 200 Ohm   - 1.0 6.0 mV
TA = 0° to +70°C - 1.0 9.0 mV
V+ = ±4V, RL = 10k Ohm to Pin7 - - 6.0 mV
Input Offset Current IIO   - 50 750 nA
TA = +70° - 0.5 1.5 µA
TA = 0° - 0.5 1.5 µA
V+ = 4V, RL = 10k Ohm to Pin7 - 50 600 µA
Input Bias Current IIB   - 0.3 1.5 µA
TA = +70° - 0.3 3.0 µA
TA = 0° - 0.3 3.0 µA
V+ = 4V, RL = 10k Ohm to Pin7 - 0.3 1.5 µA
Input Resistance ri   50 150 - k Ohm
Large Signal Voltage Gain AV VOUT = ±10V 15000 50000 - V / V
V+ = ±4V, RL = 10k Ohm to Pin7, VOUT = ±2V 15000 60000 - V / V
Positive Output Voltage Swing VO   +12 +13 - V
TA = 0° to +70° +12 +13 - V
V+ = ±4V, RL = 10k Ohm to Pin7 +2.5 +2.8 - V
Negative Output Voltage Swing VO   -14 -15 - V
TA = 0° to +70° -14 -15 - V
V+ = ±4V, RL = 10k Ohm to Pin7 -3.6 -4.0 - V
Output Resistnce ro f = 1kHz - 5.0 - k Ohm
Common Mode Rejection Ratio CMRR RS = 200 Ohm, VIN = +11.5V to -13.5V 70 90 - dB
Supply Voltage Rejection Ratio PSRR RS = 200 Ohm - 50 350 µV / V
Input Voltage Range VI   -13 - +11 V
Internal Power Dissipation   VOUT = 0   - 180 330 mW
V+ = ±4V, RL = 10k Ohm to Pin7 - 20 - mW
Supply Current ICC, IEE VOUT = 0   - 9.0 14.0 mA
V+ = ±4V, RL = 10k Ohm to Pin7 - 2.5 - mA
Broadband Noise Figure   RS = 10k Ohm, BW = 10Hz to 10kHz - 2.5 - dB
Turn-On Delay ton Open Loop, VIN = ±20mV - 0.2 - µs
Turn-Off Delay toff Open Loop, VIN = ±20mV - 0.3 - µs
Slew Rate (Unity Gain) SR C1 = 0.02µF, R1 = 33 Ohm, C2 = 10pF - 1.0 - V / µs
Channel Separation   RS = 1k Ohm, f = 10kHz - 140 - dB
Input Offset Voltage Drift   RS = 200 Ohm +25°C </= TA </= +70°C - 3.0 - µV / °C
0°C </= TA </= +25°C - 3.0 - µV / °C



Fehler und Änderungen bei technischen Daten, Abmessungen und Preisen bleiben vorbehalten. Bild kann vom Original abweichen.
Hat sich ein Fehler eingeschlichen? Bitte hier melden


Suchen Sie nach einem Ersatztypen?
Wir führen die NTE Austausch-Halbleiter in unserem Sortiment

Anmerkung zu den NTE/ECG Austauschhalbleiter:
NTE-Austauschhalbleiter (früher ECG Philips und Sylvania) sind sorgfältig ausgesuchte und erprobte Halbleiter, die einen sicheren Ersatz für Originaltypen verschiedenster Hersteller und Ursprünge für fast alle Applikationsbereiche im Wartungsdienst bieten.
Alle NTE-Austausch-Halbleiter sind einzeln in durchsichtigen Plastikbeuteln verpackt, auf welchen die wichtigsten Daten vermerkt sind. Sprachen integrierter Schaltkreis integrated circuit, kurz IC, Mikrochip Microchip integreret kredsløb integreret kredslob circuito integrado (CI) circuit intégré (CI) circuit integre (CI) circuito integrato geïntegreerde schakeling geintegreerde schakeling Tümdevre Tuemdevre

Anzahl:
Bewertungen

Kunden, die dieses Produkt gekauft haben, haben auch folgende Produkte gekauft:
Schnellsuche
0 Waren
Hersteller
Hersteller Info
andere Produkte
Sprachen
English Deutsch
Währungen