NTE5440 NTE-5440 | ECG5440 ECG-5440 | NTE Electronics
NTE5440
Silicon Controlled Rectifier (SCR)
800V, 10A, Isolated Tab TO-220
Applications:
- Temperature Control
- Motor Control
- Transformerless Power Supply Regulators
- Relay and Coil Pulsing
- Power Supply Crowbar Protection
Info as pdf-file
NTE-ECG replacement list as pdf-file
Diagrams and Info of most NTE-ECG Components
Absolute Maximum Ratings:
Anode to Cathode
Non-Repetitive Peak Voltages (t ≤ 10ms, Note 1), VDSM, VRSM . . . . . . . . . . . . . . . . . . . . . . 800V
Repetitive Peak Voltages (δ ≤ 0.01), VDRM, VRRM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 800V
Peak Working Voltages, VDWM, VRWM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400V
Continuous Voltages, VD, VR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400V
Average On-State Current, IT(AV)
(Averaged over any 20ms period) up to Th = +74°C . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.7A
RMS On-State Current, IT(RMS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9A
Repetitive Peak On-State Current, ITRM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65A
Non-Repetitive Peak On-State Current, ITSM
(t = 10ms, Half-Sinewave, TJ = +110°C prior to surge, with Reapplied VRWMmax) . 100A
I2t for Fusing (t = 10ms), I2t . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 A2 s
Rate of Rise of On-State Current after Triggering, dIT/dt
(IG = 50mA to IT = 20A, dIG/dt = 50mA/μs) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50A/μs
Gate to Cathode
Reverse Peak Voltage, VRGM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5V
Average Power Dissipation (Averaged over any 20ms period), PG(AV) . . . . . . . . . . . . . . . 500mW
Peak Power Dissipation, PGM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5W
Temperatures
Operating Junction Temperature, TJ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +110°C
Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40° to +125°C
Maximum Lead Temperature (During Soldering, less than 5sec) . . . . . . . . . . . . . . . . . . . . +275°C
Note 1. Although not recommended, higher Off-State voltages may be applied without damage, but
the thyristor may switch into the On-State. The Rate-of-Rise of On-State current should
not exceed 15A/μs.
Isolation:
Minimum From all Three Pins to External Heatsink (Peak), Visol . . . . . . . . . . . . . . . . . . . . . 1000V
Typical Capacitance from Anode to External Heatsink, Cisol . . . . . . . . . . . . . . . . . . . . . . . . . . . 12pf
Thermal Characteristics:
Thermal Resistance from Junction to External Heatsink, Rthj-h
With Heatsink Compound . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5K/W
Without Heatsink Compound . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5K/W
Thermal Resistance from Junction-to-Ambient in Free Air, RthJA
(Mounted on a printed circuit board at a = any lead length
and with copper laminate, Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55K/W
Note 2. The quoted values of RthJA should be used only when no leads of other dissipating components
run to the same tie-point.
Unser Halbleiter Katalog (ohne NTE-Sortiment)
NTE Sortiment (unser ganzes Sortiment)
Einzel-Halbleiter (ganzes Sortiment)
Fehler und Änderungen bei technischen Daten, Abmessungen und Preisen bleiben vorbehalten. Bild kann vom Original abweichen.
Hat sich ein Fehler eingeschlichen?
Bitte hier melden
Suchen Sie nach einem Ersatztypen?
Anmerkung zu den NTE/ECG Austauschhalbleiter:
NTE-Austauschhalbleiter (früher ECG Philips und Sylvania) sind sorgfältig
ausgesuchte und erprobte Halbleiter, die einen sicheren Ersatz
für Originaltypen verschiedenster Hersteller und Ursprünge für
fast alle Applikationsbereiche im Wartungsdienst bieten.
Alle NTE-Austausch-Halbleiter sind einzeln in durchsichtigen
Plastikbeuteln verpackt, auf welchen die wichtigsten Daten
vermerkt sind.